Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 132
show interfaces <interface>
Use the show interfaces command to display configuration parameters and current statistics for all
interfaces (or a specified interface).
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following are samples from various show interfaces commands:
>enable
#show interfaces t1 1/1
t1 1/1 is UP
Syntax Description
<interface> Optional. Specific interface to display. Type show interfaces ? for a complete
list of valid interfaces.
performance-statistics Optional. Displays the current 15-minute interval, the current 24-hour totals, and
all 96 stored intervals.
performance-statistics
total-24-hour
Optional. Displays the current 24-hour totals and the past seven 24-hour
intervals.
performance-statistics
<x-y>
Shows the current 15-minute interval, the current 24-hour totals, and all intervals
from x through y. This command is basically the same thing as the
performance-statistics command with the added function of allowing you to
specify a particular interval (or range of intervals) to display rather than displaying
all 96.
Note: If you wish to display the 24th interval, enter (for example)
show interface
shdsl 1/1 performance-statistics 24-24
. Entering show interface shdsl 1/1
performance-statistics 24
results in displaying the 24-hour statistics. Any
number other than 24 (between 1 and 96) results in the correct display of the
selected interval (e.g.,
show interface shdsl 1/1 performance-statistics 4
shows the 4th interval).
switchport Summary of the Layer 2 information for Ethernet connections.
version Optional. Displays current version information (e.g., model and list number,
software version, etc.) for the SHDSL interface.