Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 131
show hosts
Use the show hosts command to display information such as the domain name, name lookup service, a list
of name server hosts, and the cached list of host names and addresses on the network to which you can
connect.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Command Modes
# Enable Mode
Functional Notes
The list below describes the fields contained in the host table:
• Flags: Indicate whether the entry is permanent (P) or temporary (T) and if the entry is OK or expired
(EXP).
• Age: Indicates how old the entry is.
• Type: Shows the protocol type.
• Address: Displays the IP address for the entry.
Usage Examples
The following is sample output from the show hosts command:
>enable
#show hosts
Name/address lookup uses domain name service
DNS Proxy is disabled
Default domain is not set
Name servers are 1.1.1.1 2.2.2.2
Flags Age Type Address
Example1 (P OK) - - IP 1.1.1.1
Example2 (P OK) - - IP 2.2.2.2