Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 119
show crypto map
Use the show crypto map command to display information regarding crypto map settings.
Variations of this command include the following:
show crypto map
show crypto map interface ethernet <slot/port>
show crypto map interface frame-relay <port number>
show crypto map interface loopback <port number>
show crypto map interface ppp <port number>
show crypto map interface vlan <vlan number>
show crypto map <map name>
show crypto map <map name> <map number>
Syntax Description
interface Displays the map settings for the specified interface. Valid interfaces include:
Ethernet, frame-relay, Frame Relay sublinks, loopback, PPP, or VLAN.
<slot/port> For Ethernet interfaces, designate the slot and port number.
<port number> For Frame Relay, loopback, and PPP ports, enter the port number (range is
1-1024). For Frame-Relay sublinks, the syntax is <port#.sublink#> (range for
sublinks is 1-1007).
<map name> Enter a specific crypto map name.
<map number> Enter a specific crypto map number.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode