Command Reference Guide

SROS Command Line Interface Reference Guide Basic Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 11
enable
Use the enable command (at the Basic Command Mode prompt) to enter the Enable Command Mode. Use
the disable command to exit the Enable Command Mode. See the section enable on page 11 for more
information.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Command Modes
> Basic Command Mode
Functional Notes
The Enable Command Mode provides access to operating and configuration parameters and should be
password protected to prevent unauthorized use. Use the
enable password command (found in the Global
Configuration) to specify an Enable Command Mode password. If the password is set, access to the Enable
Commands (and all other “privileged” commands) is only granted when the correct password is entered.
Usage Examples
The following example enters the Enable Command Mode and defines an Enable Command Mode password:
>
enable
# configure terminal
(config)# enable password password
At the next login, the following sequence must occur:
>
enable
Password: ******
#