Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 106
show atm [pvc | traffic] interface atm <interface>
Use the show atm command to display information specific to the ATM interface.
Variations of this command include the following:
show atm pvc
show atm [pvc | traffic] interfaces atm <interface>
Syntax Description
pvc Shows ATM PVC information.
traffic Shows ATM traffic information.
<sub-interface number> For ATM PVC information, enter the sub-interface (x.x) number.
<atm port interface> For ATM port traffic information, enter the port ATM number 1-1023.
<atm vcl interface> For ATM VCL traffic information, enter the ATM VCL number 1-1023.1-65536.
Default Values
No default is necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following is sample output from this command:
>enable
#show atm pvc interface atm 1.1
Encap Peak Avg/Min Burst
Name VPI VCI Type SC Kbps Kbps Cells Status
atm 1.1 0 200 SNAP N/A 0 0 0 Active