Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 100
erase [<filename> | startup-config]
Use the erase command to erase the specified file.
Syntax Description
<filename> Specifies the name of the file (located in FLASH memory) to erase.
startup-config Erases the startup configuration file stored in NVRAM.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following example erases the startup configuration file stored in NVRAM:
>enable
#erase startup-config
If a new startup-configuration file is not specified before power-cycling the unit, the Secure Router OS will
initialize using a default configuration.