Command Reference Guide

SROS Command Line Interface Reference Guide Basic Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 10
BASIC MODE COMMAND SET
To activate the Basic Mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or
terminal emulator) and activating a terminal session, the following prompt displays:
Router>
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 930
All other commands for this command set are described in this section in alphabetical order.
enable on page 11
logout on page 12
ping <address> on page 13
show clock on page 15
show snmp on page 16
show version on page 17
telnet <address> on page 18
traceroute <address> on page 19