Maintenance and Service Guide

6. Remove the middle frame (see Middle frame on page 16).

7. Disconnect the battery cable from the system board (see

Battery on page 19).

Remove the receiver module:

1. Unsolder the receiver module cables (1) from the system board.

NOTE: The receiver module red cable is soldered to the system board “+” receiver module

terminal. The receiver module black cable is soldered to the system board “-” receiver module

terminal.

2. Detach the receiver module (2) from the display panel assembly. (The receiver module is attached

to the display panel assembly with double-sided adhesive.)

3. Remove the receiver module and cable.

Reverse this procedure to install the receiver module.

Receiver module