Maintenance and Service Guide

Remove the vibrator module:
1. Unsolder the vibrator module cables (1) from the system board.
NOTE: The vibrator module red cable is soldered to the system board “+” vibrator module
terminal. The vibrator module black cable is soldered to the system board “-” vibrator module
terminal.
2. Detach the vibrator module (2) from the display panel assembly. (The vibrator module is attached
to the display panel assembly with double-sided adhesive.)
3. Remove the vibrator module and cable.
Reverse this procedure to install the vibrator module.
Receiver module
Description Spare part number
Receiver module (includes cable and double-sided adhesive) 782202-001
Before removing the receiver module, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the SIM slot cover (see
SIM slot cover on page 13).
5. Remove the back cover (see
Back cover on page 14).
22 Chapter 5 Removal and replacement procedures