Hardware Reference Guide
Table Of Contents
- Product features
- Setup
- Hardware upgrades
- Serviceability features
- Warnings and cautions
- Removing and installing the access panel
- Removing and installing the access panel of the HP EliteDesk 800 35W
- Upgrading system memory
- Removing a hard drive
- Installing a hard drive
- Replacing an M.2 PCIe solid-state drive
- Replacing the WLAN module
- Installing an external antenna
- Replacing the battery
- Synchronizing the optional wireless keyboard and mouse
- Electrostatic discharge
- Computer operating guidelines, routine care and shipping preparation
- Accessibility
- Index
8. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the
battery (1). When the battery pops up, lift it out (2).
9. To insert the new battery, slide one edge of the replacement battery into the holder with the positive
side up (1). Push the other edge down until the clamp snaps over the other edge of the battery (2).
10. If your model is an EliteDesk 800 95W, replace the fan assembly.
a. Set the fan assembly in place (1).
b. Tighten the three captive screws to secure the fan assembly to the chassis (2).
32 Chapter 3 Hardware upgrades