Hardware Reference Guide
Table Of Contents
- Product features
- Setup
- Hardware upgrades
- Serviceability features
- Warnings and cautions
- Removing and installing the access panel
- Removing and installing the access panel of the HP EliteDesk 800 35W
- Upgrading system memory
- Removing a hard drive
- Installing a hard drive
- Replacing an M.2 PCIe solid-state drive
- Replacing the WLAN module
- Installing an external antenna
- Replacing the battery
- Synchronizing the optional wireless keyboard and mouse
- Electrostatic discharge
- Computer operating guidelines, routine care and shipping preparation
- Accessibility
- Index
7. Locate the solid-state drives on the system board.
8. Remove the screw securing a solid-state drive to the system board (1).
9. Grasp the solid-state drive by the sides and carefully pull it out of the socket (2).
10. Remove the screw holder from the solid-state drive (3) for use on the replacement solid-state drive.
11. Insert the screw holder into the niche on the end of the new solid-state drive (1).
12. Insert the new solid-state drive into the socket on the system board and press the solid-state drive
connectors (2) rmly into the socket.
NOTE: A solid-state drive can be installed in only one way.
22 Chapter 3 Hardware upgrades