Hardware Reference Guide
Table Of Contents
- Product features
- Setup
- Hardware upgrades
- Serviceability features
- Warnings and cautions
- Removing and installing the access panel
- Removing and installing the access panel of the HP EliteDesk 800 35W
- Upgrading system memory
- Removing a hard drive
- Installing a hard drive
- Replacing an M.2 PCIe solid-state drive
- Replacing the WLAN module
- Installing an external antenna
- Replacing the battery
- Synchronizing the optional wireless keyboard and mouse
- Electrostatic discharge
- Computer operating guidelines, routine care and shipping preparation
- Accessibility
- Index
10. Lift the DGPU up by the tab at the fan end and pull the DGPU up out of the chassis.
Installing the access panel of the HP EliteDesk 800 35W
This procedure includes installing the DGPU and the access panel.
1. Set the DGPU into the chassis and secure it to the system board with three screws: two screws at the fan
end of the DGPU and one screw at the inner corner of the opposite end of the DGPU (1).
2. Plug the fan cable into the connector (2) on the system board.
3. Place the access panel on the computer and slide it back (1).
Removing and installing the access panel of the HP EliteDesk 800 35W 13