Hardware Reference Guide
Table Of Contents
- Product features
- Hardware upgrades
- Serviceability features
- Warnings and cautions
- Removing the computer access panel
- Replacing the computer access panel
- Removing the front bezel
- Removing bezel blanks
- Replacing the front bezel
- Removing and installing the optional front bezel dust filter
- System board connections
- Upgrading system memory
- Removing or installing an expansion card
- Drive positions
- Removing and Installing drives
- Installing a security lock
- Battery replacement
- Electrostatic discharge
- Computer operating guidelines, routine care and shipping preparation
- Accessibility
- Index
8. To remove an M.2 SSD card, remove the screw that secures the card (1), lift the end of the card up (2),
and then slide the card out of the system board connector (3).
9. To install an M.2 SSD card, slide the pins on the card into the system board connector while holding the
card at approximately a 30° angle (1). Press the other end of the card down (2), and then secure the card
with the screw (3).
40 Chapter 2 Hardware upgrades