Maintenance and Service Guide

TouchPad
Description Spare part number
TouchPad L32746-001
TouchPad cable L28668-001 (Cable Kit)
Before removing the TouchPad, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 33).
5. Remove the battery (see Battery on page 35).
Remove the TouchPad:
1. Disconnect the card reader/audio cable from the system board ZIF connector (1).
2. Remove the cable from the adhesive that secures it to the TouchPad (2).
3. Disconnect the TouchPad cable from the TouchPad ZIF connector (3).
4. Remove the cable from the adhesive that secures it to the TouchPad (4).
5. Disconnect the NFC antenna cable from the NFC board ZIF connector (5).
6. Remove the six Phillips M2.0×2.0 screws (1) that secure the TouchPad to the top cover.
50 Chapter 5 Removal and replacement procedures for authorized service provider parts