Specifications

7. Remove the following Phillips screws:
(1) Three Phillips PM2.0×3.0bh screws in the battery bay
(2) Two Phillips PM2.0×3.0 screws in the ODD drive bay
8. Lift the base enclosure (1) up and forward.
9. Disconnect the speaker cable (2).
10. Remove the base enclosure.
CAUTION: When installing the base enclosure, be sure that the wireless antenna cables
routed out of the display assembly are routed and arranged properly.
Failure to follow these routing instructions can result in degradation of the computer's WLAN and
WWAN performance.
Reverse this procedure to reassemble and install the base enclosure.
Component replacement procedures 81