Specifications

4. Remove the battery (see Battery on page 49).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 60)
b. Optical drive (see
Optical drive on page 56)
c. Keyboard (see
Keyboard on page 65)
d. Modem module (see
Modem module on page 70)
e. Fan (see
Fan on page 74)
f. Heat sink (see
Heat sink on page 75)
g. Base enclosure (see
Base enclosure on page 79)
h. Display assembly (see
Display assembly on page 84)
i. System board (see
System board on page 91)
Remove the RJ-11 connector cable:
1. Position the top cover upside-down, with the front toward you.
2. Remove the RJ-11 connector (1) from the clip built into the top cover.
3. Remove the RJ-11 connector cable from the clips and routing channel (2) built into the top
cover.
4. Remove the RJ-11 connector cable from the top cover.
Reverse this procedure to install the RJ-11 connector cable.
Component replacement procedures 101