User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
22. If you need to remove the second ambient light sensor cables, disconnect the cable from the ZIF
connectors on the second ambient light sensor (1) and hub board (2), and then peel the cables o the
inside of the display back cover to remove them (3).
The second ambient light sensor cable is available in the Cable Kit as spare part number M07101-001.
Display back covers are available as the following spare part numbers:
M36307-001: Models with WWAN, Touch-on Panel (TOP), 250 nits
M36308-001: Models with WWAN, privacy, 400 nits
M36305-001: Models without WWAN, Touch-on Panel (TOP), 250 nits
M36306-001: Models without WWAN, privacy, 400 nits
23. Use the following illustration to determine proper cable routing. The WWAN antenna cables and display
cable route through the right hinge (1). The WLAN antenna cables and display cable route through the
left hinge (2).
Component replacement procedures 73