User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
15. If you need to remove the microphone board from the display, disconnect the cable from the reverse ZIF
connector on the board (1), and then use a tool (2) to release the board from the computer (3).
The microphone board is available as spare part number M07208-001 and M07209-001 for the rear-
facing third microphone.
16. If you need to remove the camera module:
▲ Use a tool (1) to lift up evenly across the module and peel the module up from the display back
cover (2), and then disconnect the cable from the reverse ZIF connector on the module (3). The
camera module is available as spare part number M07216-001 for RGB cameras and M08549-001
for IR cameras.
NOTE: For installation, note that the cable routes under the camera module before it connects to
the module.
Component replacement procedures 69