User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
m. Open the display and remove rubber spacer strips.
n. Replace the hinge cover by positioning the cover over the bottom of the display, rotating the cover
upward, sliding it to the left, and then replacing the screw.
12. If you need to remove the hub board from the display:
a. Disconnect the display cable from the ZIF connector (1) on the hub board.
b. Disconnect the camera cable from the ZIF connector (2) on the hub board.
c. Disconnect the smaller cables from the reverse ZIF connectors on the hub board (3), (4).
d. Use a tool (5) to release the board from the display rear cover (6).
The hub board is available as spare part number M07211-001 in models with an IR camera and
M07210-001 in models with an RGB camera or microphone module.
Component replacement procedures 67