User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
a. Check the t of the various alignment tools on the display assembly. Make note of the best tting
alignment tool to use when replacing the display panel.
b. The display panel is secured to the display enclosure with tape that is installed under the left and
right sides of the panel. To remove the panel, use tweezers to grasp the end of the tape (1). While
turning the tweezers, wrap the tape around the tweezers (2) as you continue to pull the tape out
from behind the display panel (3). You must pull the tape multiple times before it is completely
removed.
c. Rotate the display panel over and place it next to the display enclosure (4).
Display panels are available as the following spare part numbers:
M36316-001: 1000 nit panel
M36314-001: 250 nit panel, Touch-on Panel (TOP)
M36315-001: 250 nit panel
M36313-001: 400 nit panel
d. Lift the tape from the connector on the display panel (1), rotate the locking lever (2), and then
disconnect the cable from the panel (3).
Component replacement procedures 63