User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
a. Flex the bottom (1), the left and right sides (2), and then the top of the bezel (3) to release it.
b. Remove the bezel from the display (4).
Bezels are available as the following spare part numbers:
NOTE: When replacing the bezel, be sure that the replacement bezel matches the original bezel.
● M07163-001: IR camera and ambient light sensor
● M07164-001: IR camera
● M07165-001: RGB camera and ambient light sensor
● M07166-001: RGB camera
● M07100-001: Microphone module only (no camera module)
8. If you need to remove the hinge cover from the display enclosure:
a. Remove the Phillips M1.6 × 3.0 screw (1) that secures the hinge cover to the display.
b. Slide the hinge cover (2), rotate the bottom of the cover up, and then remove it from the display
(3).
c. Note the location of all cables hidden by the hinge cover so that you can be sure to properly route
the cables during reassembly.
The hinge cover is available in the Hinge Kit as spare part number M07104-001.
Component replacement procedures 61