User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
● Memory modules (see Memory modules on page 34).
● WLAN module (see WLAN module on page 37).
● WWAN module (see WWAN module on page 38).
● Solid-state drive (see Solid-state drive on page 40).
● Heat sink (see Heat sink on page 54).
Remove the system board:
1. Disconnect the following cables from the system board:
● Power connector cable (1)
● Camera cable (2)
● Antenna cables from the WWAN module (select products only) (3)
● Antenna cables from the WLAN module (4)
● Larger USB cable from the USB board (ZIF) (5)
● Speaker cable (6)
● Small USB cable from the USB board (7)
● Display cable (8)
● Keyboard cable (ZIF) (9)
● Card reader cable (ZIF) (10)
● Touchpad cable (ZIF) (11)
● Keyboard backlight cable (ZIF) (select products only) (12)
● RTC battery cable (13)
● NFC module cable (ZIF) (select products only) (14)
● Fingerprint reader cable (ZIF) (select products only) (15)
Component replacement procedures 57