User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
3. Remove the ngerprint reader board from the computer (4).
Reverse this procedure to install the ngerprint reader board.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table
6-8 Touchpad description and part number
Description Spare part number
Touchpad button board M07106-001
Touchpad M42237-001
Touchpad with NFC antenna M42238-001
Touchpad cable (included in Cable Kit) M07101-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 33).
2. Remove the bottom cover (Bottom cover on page 33).
3. Remove the battery (see Battery on page 43).
Remove the touchpad:
1. Disconnect the system board cable from the ZIF connector on the touchpad (1).
2. Disconnect the middle cable from the ZIF connector on the touchpad (2).
3. Disconnect the touchpad button board cable from the ZIF connector on the touchpad (3).
4. Disconnect the cable from the ZIF connector on the system board (4).
5. Remove the four Phillips M1.6 × 1.8 screws (5) that secure the touchpad to the computer.
Component replacement procedures 51