User Manual
Table Of Contents
- Product description
- Components
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Customer Self-Repair parts
- Removal and replacement procedures for authorized service provider parts
- Computer Setup (BIOS), TPM, and HP Sure Start
- Backing up, restoring, and recovering
- Using HP PC Hardware Diagnostics
- Using HP PC Hardware Diagnostics Windows (select products only)
- Using HP PC Hardware Diagnostics UEFI
- Using Remote HP PC Hardware Diagnostics UEFI settings (select products only)
- Specifications
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
3. Remove the power connector cable from the computer (3).
Reverse this procedure to install the power connector cable.
USB board
To remove the USB board, use this procedure and illustration.
Table
6-6 USB board description and part number
Description Spare part number
USB board M36398-001
USB board cables (included in Cable Kit) M07101-001
USB bracket (included in Bracket Kit) M08556-001
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 33).
2. Remove the bottom cover (Bottom cover on page 33).
3. Disconnect the battery cable from the system board (see Battery on page 43).
Remove the USB board:
1. Disconnect the smaller cable from the USB board (1).
2. Disconnect the larger cable from the ZIF connector on the USB board (2).
3. Remove the three Phillips M2.0 × 4.0 screws (3) that secure the board to the computer, and then remove
the bracket from the board (4).
Component replacement procedures 49