Installation guide

11
(1)
A
uxiliary
g
roundin
g
point 2 (2) Rear mountin
g
position
(3) Primary grounding point (4) Auxiliary grounding point 1
(5) Front mountin
g
position
Figure 7 Mounting and grounding positions of the HP 5900AF-48G-4XG-2QSFP+/HP
5900AF-48G-4XG-2QSFP+ TAA switch
(1) Auxiliary
g
roundin
g
point 2 (2) Rear mountin
g
position
(3) Primary
g
roundin
g
point (4)
A
uxiliary
g
roundin
g
point 1
(5) Front mounting position
Attaching the mounting brackets and chassis rails to the chassis
1. Align the mounting brackets with the screw holes in the rear mounting position or front mounting
position. See Figure 8 and Figure 9.
2. Use M4
screws (provided) to attach the mounting brackets to the chassis.
3. Align the chassis rails with the rail mounting holes in the chassis:
{ If the mounting brackets are in the rear mounting position, align the chassis rails with the screw
holes at the front of the side panels. See Figure 8.
{ If the mounting brackets are in the front mounting position, align the chassis rails with the screw
holes at the rear of the side panels. See Figure 9.
4. Use M4
screws (provided) to attach the chassis rails to the chassis.
NOTE:
Secure the mounting brackets and chassis rails to both sides of the chassis in the same way.
Connecting the grounding cable
CAUTION:
The primary grounding point and auxiliary grounding point 1 are located on the left side panel. If you use
one of these grounding points, you must connect the grounding cable to the grounding point before you
mount the switch in the rack.
1
2
3
4 5