Installation guide

8
3. Align the two-hole grounding lug at one end of the cable with the grounding holes of the grounding
point, insert the grounding screws into the holes, and tighten the screws with a screwdriver to attach
the grounding lug to the chassis, as shown in Figure 6.
NOTE:
 HP recommends that you use the primary grounding point or auxiliary grounding point 1 because the grounding
cable and grounding screw that come with the switch are suitable only for these two grounding points.
 To use auxiliary grounding point 2 on the HP 5900AF-48XG-4QSFP+ switch, you must prepare a grounding cable
yourself.
Figure 6 Attaching the rear mounting brackets/chassis rails/grounding cable to the chassis
Figure 7 Attaching the front mounting brackets/chassis rails to the chassis