Datasheet

Security
SecuritySecurity
Security Power-on password
Setup password
SSH and SSL Encryption
UPS and PDU Power
UPS and PDU PowerUPS and PDU Power
UPS and PDU Power
Cord Matrix
Cord MatrixCord Matrix
Cord Matrix
Please see the UPS and PDU cable matrix's on the HP Power Protection and Management page. Under
Power Cords, click on the "HP Power Cord Matrix" link. That link will list cable descriptions, requirements,
and specifications for UPS and PDU units. Please see the following link:
www.hp.com/products/powercords .
Power Supply
Power SupplyPower Supply
Power Supply 500 Watts, auto-switching, high efficiency, PFC (Power Factor Correcting).
System Fans
System FansSystem Fans
System Fans 6 system fans ship standard; non-hot plug, non-redundant
Operating Systems and
Operating Systems andOperating Systems and
Operating Systems and
Virtualization Software
Virtualization SoftwareVirtualization Software
Virtualization Software
Support for ProLiant
Support for ProLiantSupport for ProLiant
Support for ProLiant
Servers
ServersServers
Servers
Microsoft Windows Server
Microsoft Windows Server 2008 Hyper V
Red Hat Enterprise Linux (RHEL)
SUSE Linux Enterprise Server (SLES)
Solaris 10 for x86/x64 based Systems
NOTE:
NOTE:NOTE:
NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and Virtualization
Software and latest listing of software drivers available for your server, please visit our Support Matrix at:
http://www.hp.com/go/supportos and our driver download page
http://www.hp.com/support/DL165G6 .
Rack Airflow
Rack AirflowRack Airflow
Rack Airflow
Requirements
RequirementsRequirements
Requirements
Rack 10000 G2 series Cabinets
Rack 10000 G2 series CabinetsRack 10000 G2 series Cabinets
Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for maximum
cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION:
CAUTION:CAUTION:
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors, you must allow
5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to permit adequate
airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be a
minimum of 7 cm (2.75 inches)
CAUTION:
CAUTION:CAUTION:
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling
that can lead to thermal damage.
Rack Support
Rack SupportRack Support
Rack Support The DL Fixed Rail System supports installation in racks with square or round mounting holes (including
Compaq/HP 7000, 9000, 10000 and HP series), with an adjustment range of 24" - 36".
QuickSpecs
HP ProLiant DL165 Generation 6 (G6)
HP ProLiant DL165 Generation 6 (G6)HP ProLiant DL165 Generation 6 (G6)
HP ProLiant DL165 Generation 6 (G6)
Standard Features
DA - 13367 Worldwide — Version 10 — September 3, 2010 Page 6