Reference Guide

Full Command and Function Reference 3-125
KEYTIME →
Type: Command
Description: Displays the current keytime value.
Keytime is the time after a keypress during which further keypresses will not be actioned. It is
measured in ticks. If you experience key bounce, you can increase the value of keytime.
Access: …µ KEYTIME →
Input/Output:
Level 1/Argument 1 Level 1/Item 1
→
time
See also: →KEYTIME
KGET
Type: Command
Description: Kermit Get Command: Used by a local Kermit to get a Kermit server to transmit the named
object(s).
To rename an object when the local device gets it, include the old and new names in an embedded
list. For example, {{ AAA BBB }} KGET gets the variable named AAA but changes its name to
BBB. {{ AAA BBB } CCC } KGET gets AAA as BBB and gets CCC under its own name. (If the
original name is not legal on the calculator, enter it as a string.)
Access: …µ KGET
Flags: I/O Device (–33), RECV Overwrite (–36), I/O Messages (–39), I/O Device for Wire (–78)
Input/Output:
Level 1/Argument 1 Level 1/Item 1
'
name
'
→
“name”
→
{ name
old
name
new
}
→
{ name
1
... name
n
}
→
{{ name
old
name
new
} name ... }
→
See also: BAUD, CKSM, FINISH, PARITY, RECN, RECV, SEND, SERVER, TRANSIO
KILL
Type: Command
Description: Cancel Halted Programs Command: Cancels all currently halted programs. If KILL is executed
within a program, that program is also canceled.
Canceled programs cannot be resumed.
KILL cancels only halted programs and the program from which KILL was executed, if any.
Commands that halt programs are HALT and PROMPT.
Suspended programs cannot be canceled. Commands that suspend programs are INPUT and
WAIT.
Access: !°LL RUN & DEBUG KILL ( °is the left-shift of the Nkey).
Input/Output: None
See also: CONT, DOERR, HALT, PROMPT
LABEL
Type: Command
Description: Label Axes Command: Labels axes in PICT with x- and y-axis variable names and with the
minimum and maximum values of the display ranges.
The horizontal axis name is chosen in the following priority order:
1. If the axes parameter in the reserved variable PPAR is a list, then the x-axis element from that
list is used.