Installation Manual

2 Installing the HP 501
The HP 501 is suited for indoor installation on a desktop, wall, ceiling, or in a plenum. The end
user is responsible for ensuring that installation and use comply with local safety and radio
regulations.
IMPORTANT: This device requires professional installation. Consult a professional installer trained
in RF installation and knowledgeable in local regulations including:
• Building and wiring codes
• Safety regulations
• Channel, power, and indoor/outdoor restrictions
• License requirements for the intended country
For ceiling and wall installations, HP highly recommends that you use the included spring clips
with the mounting bracket as shown to ensure a secure fit.
Figure 2 Mounting bracket and spring clips
2. Mounting bracket1. Spring clip
Remove product from packaging
Inspect the package contents and verify that they are free from defects. The package contains:
• The HP 501 Wireless Client Bridge
• A mounting bracket
• Two spring clips
• Three dual-band omnidirectional antennas
• Two mounting screws with wall anchors
• One cable-tie
• Documentation
6 Installing the HP 501