Installation Manual

4. Reconnect your computer to the HP 501.
5. Confirm that your wireless network interface is still disabled (it was disabled during an earlier
configuration step).
6. Enable the computer Ethernet network interface, and verify that it is set to automatically obtain
an IP address from DHCP.
7. Confirm that you can browse the Internet from your computer.
You can perform additional configuration procedures by launching the HP 501 management tool
at https://IP_address where IP_address is the IP address that the HP 501 obtained from the DHCP
server or that was statically configured in the HP 501 earlier. For more information, see HP 501
802.11ac Wireless Client Bridge Configuration and Administration Guide.
12 Initial configuration