Command Reference Guide

168 ● interface serial [ p2p | p2mp ] 3Com Router 5000 Family and Router 6000 Family
Command Reference
interface serial [ p2p | p2mp ]
Purpose Use the interface serial [ p2p | p2mp ] command to configure type of the
specified FR subinterface and enter frame relay subinterface view.
Use the undo interface serial [ p2p | p2mp ] command to restore the
default frame relay subinterface type.
Syntax interface serial interface-number.subinterface-number [ p2p | p2mp ]
undo interface serial interface-number.subinterface-number [ p2p | p2mp
]
Parameters interface-number.
subinterface-number
Specifies a subinterface, with valid numbers for
subinterface-number from 1 to 1024.
p2p
Point-to-point subinterface.
p2mp
Point-to-multipoint subinterface.
Default By default, the link-layer protocol encapsulated on the interface is PPP, and the Frame
Relay encapsulation format is IETF.
FR subinterface type defaults to p2mp.
Example Configure a point-to-point FR subinterface s0/0/0.1.
[Router] interface serial0/0/0.1 p2p
View This command can be used in the following views:
■ System view