Command Reference Guide

156 ● fr map ipx 3Com Router 5000 Family and Router 6000 Family
Command Reference
fr map ipx
Purpose Use the fr map ipx command to add an IPX address map entry.
Use the undo fr map ipx command to remove an IPX address map entry of FR.
Syntax fr map ipx protocol-address dlci [ broadcast ] [ nonstandard | ietf ] [
compression frf9 ]
undo fr map ipx protocol-address dlci
Parameters protocol-address
IPX address of the remote host.
dlci
Local virtual circuit number. Valid values are 16 to
1007.
broadcast
Specifies if broadcast packets can be sent using the
map.
nonstandard
The map adopts nonstandard compatible
encapsulation format.
ietf
The map adopts IETF encapsulation format. In this
case, only FRF9 can be adopted.
compression frf9
Enables FRF.9 compression.
Default By default, no static address map entry exists.
Example Create a static IPX address map entry on interface Serial 0/0/0, where DLCI 50 is
connected to the remote IPX address 100.00e0-fc32-4802.
[Router-Serial0/0/0] fr map ipx 100.00e0-fc32-4802 50
View This command can be used in the following views:
■ Interface view
Description You can create an address map manually or by using InARP. InARP is suitable for a
complex network where the remote router also supports InARP. When the number of
remote hosts is small or when default routes exist, however, manual map creation is
preferred.
The priority of a static address map entry is higher than that of a dynamic address
map entry. When a dynamic address map entry is found to be the same as a static
address map entry, it is automatically removed.