Command Reference Guide

154 ● fr map ip 3Com Router 5000 Family and Router 6000 Family
Command Reference
fr map ip
Purpose Use the fr map ip command to add an IP address map entry for FR.
Use the undo fr map ip command to remove an IP address map entry for FR.
Syntax fr map ip { protocol-address [ ip-mask ] | default } dlci [ broadcast ]
[ nonstandard [compression iphc connections number ] | ietf [
compression [ frf9 | iphc connections number ] ] ]
fr map ip { protocol-address [ ip-mask ] | default } pvc-group
pvc-group-name [ nonstandard | ietf | broadcast ]*
undo fr map ip { protocol-address | default } { dlci | pvc-group
pvc-group-name }
Parameters protocol-address
Peer protocol address.
ip-mask
IP mask used to establish a network segment map.
dlci
Local virtual circuit number. Valid values are 16 to
1007.
pvc-group-name
PVC group name. Specify this argument when a PVC
has been created on the interface.
default
Creates a default map.
broadcast
Specifies if broadcast packets can be sent using the
map.
nonstandard
The map adopts nonstandard compatible
encapsulation format. In this case, only IPHC
compression can be adopted. PVC groups does not
support compression.
ietf
The map adopts IETF encapsulation format. In this
case, only FRF9 and IPHC can be adopted. PVC groups
does not support compression.
compression
Enables frame relay compression.
frf9
Adopts payload compression.
iphc
Adopts IP, UDP, or RTP header compression.
connections number
RTP compression connection number.
Default By default, no static address map entry exists and InARP is enabled.
Example Create a static address map entry on interface Serial 1/0/0, where DLCI 50 is
connected to the router with IP address 202.38.163.252.
[3Com-Serial1/0/0] fr map ip 202.38.163.252 50