Command Reference Guide

150 ● fr lmi n393dte 3Com Router 5000 Family and Router 6000 Family
Command Reference
fr lmi n393dte
Purpose Use the fr lmi n393dte command to set N393 parameter at the DTE side.
Use the undo fr lmi n393dte command to restore the default configuration.
SyntaxSyntax fr lmi n393dte n393-value
undo fr lmi n393dte
Parameters Event counter. In the range 1 to 10.
Default By default, the parameter value is 4.
Example Set the operation of frame relay interface Serial1/0/0 as the DTE mode and sets N392
to 5 and N393 to 6.
[3Com-Serial1/0/0] link-protocol fr
[3Com-Serial1/0/0] fr interface-type dte
[3Com-Serial1/0/0] fr lmi n392dte 5
[3Com-Serial1/0/0] fr lmi n393dte 6
View This command can be used in the following views:
■ Interface view
Description The DTE sends a Status-Enquiry packet at a regular interval to the DCE to inquire the
link status. On receiving this packet, the DCE will immediately send a Status-Response
packet. If the DTE does not receive the response packet in the specified time, it will
record the error by adding 1 to the error count. If the errors exceed the threshold, the
DTE will consider that the physical channels and all the DLCIs to be unavailable.
N392 and N393 together define the “error threshold”. N393 indicates the event
number observed and N392 indicates the error threshold of that number (N393). That
is, if N392 errors occurred in N393 Status-Enquiry packets in the DTE, the DTE would
consider that the error count had exceeded the threshold and declare the physical
channels and all DLCIs to be unavailable.
N392 at DTE side should be less than N393 at DTE side.
Related Commands ■ fr interface-type
■ fr lmi n392dte