Command Reference Guide

3Com Router 5000 Family and Router 6000 Family fr lmi n392dce ● 147
Command Reference
fr lmi n392dce
Purpose Use the fr lmi n392dce command to set N392 parameter at the DCE side.
Use the undo fr lmi n392dce command to restore the default configuration.
Syntax fr lmi n392dce n392-value
undo fr lmi n392dce
Parameters n392-value
Error threshold. Valid values are 1 to 10.
Default By default, the parameter value is 3.
Example Set the operation of frame relay interface Serial1/0/0 as DCE mode and sets N392 to 5
and N393 to 6.
[3Com] interface Serial1/0/0
[3Com-Serial1/0/0] link-protocol fr
[3Com-Serial1/0/0] fr interface-type dce
[3Com-Serial1/0/0] fr lmi n392dce 5
[3Com-Serial1/0/0] fr lmi n393dce 6
View This command can be used in the following views:
■ Interface view
Description The DCE requires the DTE to send a Status-Enquiry packet at regular interval (set by
T392). If the DCE does not receive the Status-Enquiry packet within a period of time,
it will record the error by adding 1 to the error count. If the errors exceed the
threshold, the DCE would consider the physical channels and all the DLCIs to be
unavailable.
N392 and N393 together define the “error threshold”. N393 defines the event
number observed and N392 defines the error threshold of that number (N393). That
is, if number of errors that occurred to the DCE reaches N392 in N393 events, DCE
will consider the errors have reached the threshold and declare the physical channels
and all DLCIs to be unavailable.
N392 should be less than N393.
Related Commands ■ fr interface-type
■ fr lmi n393dce