Command Reference Guide

146 ● fr lmi n391dte 3Com Router 5000 Family and Router 6000 Family
Command Reference
fr lmi n391dte
Purpose Use the fr lmi n391dte command to configure N391 parameter at the DTE side.
Use the undo fr lmi n391dte command to restore the default value.
Syntax fr lmi n391dte n391-value
undo fr lmi n391dte
Parameters n391-value
Status counter of the PVC. Valid values are 1 to 255.
Default By default, its value is 6.
Example Set DTE as the operating mode of Frame Relay interface Serial1/0/0, and the counter
value of the PVC status to 10.
[3Com-Serial1/0/0] link-protocol fr
[3Com-Serial1/0/0] fr interface-type dte
[3Com-Serial1/0/0] fr lmi n391dte 10
View This command can be used in the following views:
■ Interface view
Description The DTE sends a Status-Enquiry packet at regular interval set by T391 to the DCE.
There are two types of Status-Enquiry packets: link integrity authentication packet
and link status enquiry packet. The N391 parameter defines the ratio of sending the
two types of packets, that is, link integrity authentication packets: link status enquiry
packets = (N391 - 1): 1.
Related Command fr interface-type