Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display pppoe-server session ● 115
Command Reference
display pppoe-server session
Purpose Use the display pppoe-server session command to view the status and
statistics of PPPoE session.
Syntax display pppoe-server session { all | packet | statistics interface
interface-type interface-number }
Parameters all
Displays all information about each PPPoE session.
packet
Displays statistics about the packets on each PPPoE
session.
statistics
Displays the statistics information of PPPoE sessions
over an interface.
interface-type
interface-number
Specifies an interface.
Example View all the session information of PPPoE.
<3Com> display pppoe-server session all
There is 1 session in total:
SID Intf OIntf RemMAC LocMAC
State
1 Virtual-Template1:1 GigabitEthernet1/0/0 00e0fc000501
00e0fc000100 UP
View the statistics information of PPPoE session.
<3Com> display pppoe-server session packet
SID RemMAC LocMAC InP InO InD OutP OutO OutD
1 0050ba1a02ce 0001af02a40f 42 2980 0 16 343 0
Table 1 Output information description
Field Description
There is 1 session in
total:
Display total number of sessions for PPPoE
SID Session Identifier
Intf The corresponding Virtual-Template interface
OIntf corresponding Ethernet interface
RemMAC Remote MAC address
LocMAC Local MAC address
SID Session Identifier
Table 2 Description of the output
Field Description
InP In Packets, Packages received
InO In Octets, Bytes received
InD In Discards, Received and then discarded packages
OutP Out Packets, Packages sent