Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display fr map-info ● 87
Command Reference
display fr map-info
Purpose Use the display fr map-info command to view all FR address maps or the one
for the specified interface.
Syntax display fr map-info [ interface interface-type interface-num ]
Parameters interface-type
interface-num
Specifies an interface. It can be a main interface or a
sub-interface.
Example Display frame relay address map table.
<3Com> display fr map-info
Map Statistics for interface Serial1/0/2 (DTE)
DLCI = 100, IP INARP 100.100.1.1, Serial1/0/2
create time = 2002/10/21 14:48:44, status = ACTIVE
encapsulation = ietf, vlink = 14, broadcast
DLCI = 200, IP INARP 100.100.1.1, Serial1/0/2
create time = 2002/10/21 14:34:42, status = ACTIVE
encapsulation = ietf, vlink = 0, broadcast
DLCI = 300, IP 1.1.1.1, Serial1/0/2
create time = 2002/10/21 15:03:35, status = ACTIVE
encapsulation = ietf, vlink = 15
View This command can be used in the following views:
■ Any view
Description This command displays whether the static address map entries are correct and
whether dynamic address mapping operates normally.
Related Commands ■ fr map ip
■ fr inarp
Table 1 Description on the fields of the display fr map-info command
Field Description
Map Statistics for interface
Serial1/0/2 (DTE)
Display the frame relay address map
DLCI = 100, IP INARP
100.100.1.1, Serial1/0/2
The PVC with DLCI 100 is mapped to remote IP address 100.100.1.1
through INARP
create time = 2002/10/21
14:48:44
Time and date when the map entry was created
status = ACTIVE State of the map entry
encapsulation = ietf Encapsulation is set to IETF
broadcast Broadcasts are permitted