Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display fr compress ● 81
Command Reference
display fr compress
Purpose Use the display fr compress command to view the statistics information of the
frame relay compression.
Syntax display fr compress [ interface interface-type interface-number ]
Parameters interface-type
interface-number
Specifies an interface.
Example View the frame relay compression statistics information of MFR interface 4/0/0.
<3Com> display fr compress
Serial2/0/0-DLCI:100
enable frame-relay compression
Uncompressed Octets out/in : 766/0 Compressed Octets out/in : 329/0
1 min avg ratio xmt/rcv:0.42/0.00 5 min avg ratio
xmt/rcv:0.42/0.00
View This command can be used in the following views:
■ Any view
Description If no interface is specified, the DLCI statistics information of all the interfaces will be
displayed.
Related Command fr compression frf9
Table 1 Description on the fields of the display fr compress command
Field Description
enable frame-relay compression Frame relay compression is enabled
Uncompressed Octets out/in : 766/0 Uncompressed transmitted /received octets
Compressed Octets out/in : 329/0 Compressed transmitted/received octets
1 min avg ratio xmt/rcv:0.42/0.00 In one minute, average transmission/receiving rate
5 min avg ratio xmt/rcv:0.42/0.00 In five minutes, average transmission/receiving rate