Command Reference Guide

78 ● display bridge traffic 3Com Router 5000 Family and Router 6000 Family
Command Reference
display bridge traffic
Purpose Use the display bridge traffic command to view the traffic statistics on an
interface.
Syntax display bridge traffic [ bridge-set bridge-set | interface
interface-type interface-number | dlsw ]
Parameters bridge-set
Bridge set number. Valid values are 1 to 255.
interface-type
Interface type.
interface-number
Interface number.
dlsw
Display the information of the traffic through DLSW
module.
Example Display the traffic information on Ethernet0/0/0.
[3Com] display bridge traffic interface ethernet 0/0/0
The information displayed and described in the following table is:
the statistic of interface Ethernet0/0/0 in bridge set 1 :
Input:
10 total, 1 bpdu, 2 single,
0 multi, 0 broadcast;
0 ip,0 ipx, 0 other protocol;
0 eth2, 0 snap,
0 dlsw, 0 other,
0 vlan;
Output:
0 total, 0 bpdu, 0 single,
0 multi, 0 broadcast;
0 ip, 0 ipx, 0 other protocol;
0 eth2, 0 snap,
0 dlsw, 0 other,
0 vlan;
Send Way: 0 broadcast, 0 fast, 0 other
Discard:
0 by inport state,
0 for local frame ,
0 by mac table,
0 by inport filter,
0 by outport filter,
0 by ip filter ,
0 other