Command Reference Guide

66 ● display atm map-info 3Com Router 5000 Family and Router 6000 Family
Command Reference
display atm map-info
Purpose Use the display atm map-info command to view the information about the
upper layer protocol mapping table of ATM.
Syntax display atm map-info [ interface interface-type interface-num [ pvc {
pvc-name | vpi/vci } ] ]
Parameters interface-type
Interface type, specifies an ATM interface together
with
interface-num.
interface-num
Interface number, specifies an ATM interface together
with
interface-type.
pvc-name
PVC name, optional parameter. If no PVC name and
no VPI/VCI pair are specified, the information of the
higher layer protocol mapping table about all PVCs
within specified ATM interface will be displayed by
default.
vpi/vci
VPI/VCI pair, optional. For more details, please refer to
“Parameter Description” in the pvc command.
Default If no interface is specified, information about the upper layer protocol maps on all
ATM interfaces is displayed by default.
Example Display information about the upper layer protocol mapping table on all ATM
interfaces.
<3Com> display atm map-info
Atm1/0/0, PVC 1/32, PPP, Virtual-Template10, UP
Atm1/0/0, PVC 1/33, IP & Mask, State UP
100.11.1.1, mask 255.255.0.0, vlink 1
Atm1/0/0, PVC 2/101, ETH, Virtual-Ethernet1/1/1, MAC 00E0.FC01.0203, UP
View This command can be used in the following views:
■ Any view
Table 1 Description on the fields of the display atm map-info command
Field description
Atm1/0/0 Interface type and interface number
PVC 1/32 PVC identifier
PPP Protocol type
Virtual-Template10 Associated virtual template
State UP Map entry state
100.11.1.1, mask
255.255.0.0
Protocol address
Vlink 1 Virtual link number