Command Reference Guide

44 ● debugging fr 3Com Router 5000 Family and Router 6000 Family
Command Reference
debugging fr
Purpose Use the debugging fr command to enable frame relay information debugging.
Use the undo debugging fr command to disable frame relay information
debugging.
Syntax debugging fr { all | congestion | de | event | fragment | inarp | lmi |
mfr control | packet | transmit-rate } [ interface interface-type
interface-number [ dlci dlci-number ] ]
undo debugging fr { all | congestion | de | event | fragment | inarp |
lmi | mfr control | packet | transmit-rate } [ interface interface-type
interface-number [ dlci dlci-number ] ]
Parameters all
All frame relay information debugging.
congestion
Information debugging of frame relay traffic
congestion management.
de
DE information debugging of FRTS.
event
Information debugging of frame relay event. When
this parameter is used, no interface can be specified.
fragment
Information debugging of frame relay fragment. When
this parameter is in use, interface and DLCI must be
specified.
inarp
Information debugging of frame relay address
resolution protocol. When this parameter is in use,
DLCI can be specified.
lmi
Information debugging of frame relay LMI (Local
Management Interface) protocol.
mfr control
Information debugging of multilink frame relay bundle
and bundle link.
packet
Information debugging of frame relay packet. When
this parameter is in use, DLCI can be specified.
transmit-rate
Information debugging of FRTS transmit rate.
interface-type
Interface type.
interface-number
Interface number.
dlci dlci-number
DLCI number of virtual circuit. Valid values are 16 to
1007.
Default By default, frame relay information debugging is disabled.