Command Reference Guide

24 ● bridge stp ieee 3Com Router 5000 Family and Router 6000 Family
Command Reference
bridge stp ieee
Purpose Use the bridge stp ieee command to specify a bridge set to support IEEE STP.
Use the undo bridge stp ieee command to disable a bridge set to support STP.
Syntax bridge bridge-set stp ieee
undo bridge bridge-set stp ieee
Parameters bridge-set
Number of a bridge set. Valid values are an integer
between 1 and 255.
ieee
Ethernet spanning tree protocol (STP).
Default The default STP standard supported on a bridge set is IEEE.
Example Set the STP standard supported by a bridge set to IEEE.
[Router] bridge 1 stp ieee
View This command can be used in the following views:
■ System view
Description STP has multiple standards, which are not compatible. To prevent bridging loops, the
communicating parties must use the same STP standard.