Command Reference Guide

20 ● bridge-set 3Com Router 5000 Family and Router 6000 Family
Command Reference
bridge-set
Purpose Use the bridge set command to add an interface to a bridge set.
Use the undo bridge set command to delete the interface from the bridge set.
Syntax bridge-set bridge-set
undo bridge-set bridge-set
Parameters bridge-set
Bridge set number. Valid values are an integer from 1
to 255.
Default By default, no interface is added to the bridge set.
Example Add Ethernet0/0/0 to bridge set 1.
[3Com] interface ethernet0/0/0
[3Com-Ethernet0/0/0] bridge-set 1
Add interface dialer 0 to bridge set 1.
[3Com] interface Dialer0
[3Com-Dialer0] bridge-set 1
View This command can be used in the following views:
■ Interface view
■ Bridge TSemplate view
Description Bridging can only be implemented between interfaces of a same bridge set.
If VRRP is enabled on the bridge template corresponding to a bridge set,
non-Ethernet interface is not allowed to be added to this bridge set.
When configuring bridge over dial interface, you need to configure this command on
the top-layer dial interface.