Command Reference Guide

18 ● bridge routing 3Com Router 5000 Family and Router 6000 Family
Command Reference
bridge routing
Purpose Use the bridge routing command to enable the routing function of a specified
bridge-set for the specified network protocol.
Use the undo bridge routing command to disable the routing function of the
bridge-set for the specified network protocol.
Syntax bridge bridge-set routing { ip | ipx }
undo bridge bridge-set routing { ip | ipx }
Parameters bridge-set
Bridge-set number. Valid values are 1 to 255.
ip
IP
ipx
IPX
Default By default, the routing function is disabled.
Example Enable IP routing in bridge-set 1.
[Router] bridge 1 routing ip
View This command can be used in the following views:
■ System view
Description When a bridge is configured to route for a particular network protocol, the PDUs of
the protocol are routed if needed.