Command Reference Guide

12 ● bridge aging-time 3Com Router 5000 Family and Router 6000 Family
Command Reference
bridge aging-time
Purpose Use the bridge aging-time command to configure the aging time of the
dynamic address table.
Use the undo bridge aging-time command to restore the default aging time of
the dynamic address table.
Syntax bridge aging-time seconds
undo bridge aging-time
Parameters seconds
Aging time of the dynamic address table (in seconds).
Valid values are 10 to 1,000,000.
If no value is specified, the default aging time of a
dynamic address table is 300 seconds.
Example Configure the aging time of the dynamic address table to 500 seconds.
[3Com] bridge aging-time 500
View This command can be used in the following views:
■ System view
Description Upon the timeout of the timer, the dynamic address entries will be deleted.