Command Reference Guide

3Com Router 5000 Family and Router 6000 Family annexg ● 7
Command Reference
annexg
Purpose Use the annexg command to enable T1.617 Annext G on the frame relay interface
for data transmission.
Use the undo annexg command to disable T1.617 Annext G on the frame relay
interface.
Syntax annexg { dte | dce }
undo annexg { dte | dce }
Parameters dte
Annex G DTE mode.
dce
Annex G DCE mode.
Default By default, T1.617 Annext G is disabled on the frame relay interface.
Example Enable T1.617 Annext G on a frame relay interface for data transmission.
[Router-fr-dlci-Serial1/0/0-200] annexg dte
View This command can be used in the following views:
■ DLCI view