Command Reference Guide

334 ● using (CT3 Interface) 3Com Router 5000 Family and Router 6000 Family
Command Reference
using (CT3 Interface)
Purpose Use the using command to configure the operating mode of a CT3 interface.
Use the undo using command to restore the default or channelized mode.
Syntax using { t3 | ct3 }
Parameters t3
Sets the CT3 interface to work in unchannelized mode.
ct3
Sets the CT3 interface to work in channelized mode.
Example Configure the interface T3 1/0/0 to work in unchannelized mode.
[3Com -T3 1/0/0] using t3
View This command can be used in the following views:
■ CT3 Interface view
Description Only when the CT3 interface is working in channelized mode can you configure the
T1 lines on it.
When the CT3 interface is working in unchannelized mode, the system automatically
creates a serial interface numbered serial
number / 0:0 for it. This interface operates
at 44.736 Mbps and has the same logic features of a synchronous serial interface on
which you can make other configurations.