Command Reference Guide

3Com Router 5000 Family and Router 6000 Family using (CE3 Interface) ● 333
Command Reference
using (CE3 Interface)
Purpose Use the using command to configure the operating mode of a CE3 interface.
Use the undo using command to restore the default setting.
Syntax using { e3 | ce3 }
undo using
Parameters e3
Sets the CE3 interface to work in unchannelized mode.
ce3
Sets the CE3 interface to work in channelized mode.
Default By default, the CE3 interface is working in channelized mode.
Example Configure the interface E3 1/0/0 to work in unchannelized mode.
[3Com -E3 1/0/0] using e3
View This command can be used in the following views:
■ CE3 Interface view
Description Only when the CE3 interface is working in channelized mode can you configure the
E1 lines on it.
When the CE3 interface is working in unchannelized mode, the system automatically
creates a serial interface numbered serial
number / 0:0 for it. This interface operates
at 34.368 Mbps and has the same logic features of a synchronous serial interface on
which you can make other configurations.
Related Command controller e3