Command Reference Guide

3Com Router 5000 Family and Router 6000 Family t1 channel-set ● 315
Command Reference
t1 channel-set
Purpose Use the t1 channel-set command to bundle timeslots on the T1 channel.
Use the undo t1 channel-set command to remove the bundle.
Syntax t1 t1-number channel-set set-number timeslot-list range [ speed { 56k |
64k } ]
undo t1 t1-number channel-set set-number
Parameters t1-number
Number of a T1 channel on the CPOS interface. Valid
values are 1 to 84.
set-number
Channel set number. Valid values are 0 to 23.
range
Timeslots assigned to the channel set.
speed
Specifies how timeslots are bundled. If 56k applies, the
timeslots form an N ¥ 56 kbps bundle. If 64k applies,
timeslots form an N ¥ 64 kbps bundle. If the speed is
not specified, the default 64 kbps applies
.
Example Bundle timeslots on T1 channel 1.
<3Com > system-view
[3Com ] controller cpos 1/0/0
[3Com -Cpos1/0/0] t1 1 channel-set 1 timeslot-list 0-23
Enter the serial interface view after the bundling operation.
[3Com -Cpos1/0/0] quit
[3Com ] interface serial 1/0/0/1:1
[3Com -Serial1/0/0/1:1]
View information on the serial interface formed by the timeslot bundle.
<3Com > display interface serial 1/0/0/1:1
View This command can be used in the following views:
■ CPOS Interface view
Description T1 commands are available with the CPOS(T) interface module but not with the
CPOS(E) interface module.
Related Command t1 unframed